2009—2011年包头市大气中颗粒物浓度分析

本文通过对内蒙古包头市2009—2011年PM10浓度和TSP浓度的测定,分析了大气中颗粒物浓度的含量状况。结果表明：2009年3月到9月份之间,出现6次沙尘天气,并且颗粒物浓度超过大气空气质量三级标准,其中最严重的一次PM10浓度达到1．147mg／m^3。PM10浓度一天的变化中,在下午5时和晚间10时达到两个峰值,分别是1．608mg／m^3和1．882mg／m^3。2010年中十一月份的TSP日平均浓度较高,比八月份TSP浓度高7倍。2011年春季空气中颗粒物污染较重,在沙尘天气发生期间,颗粒物浓度含量较高     

杭州市环境保护背景下的工业产业发展研究

通过对杭州市工业产业发展现状的调研,分析杭州市工业产业发展与环境保护之间存在的问题,制定产业发展的环境约束指标,引导发展符合资源节约型、环境友好型的产业,在保持经济高度增长的同时降低污染物排放,最终形成节约资源和保护环境的产业结构.杭州市在今后一段时期内,需进一步明确各区域产业发展重点,利用总量减排倒逼产业结构调整和优化升级,积极推进行业发展环境准入,区域建设项目环境准入,最终实现经济效益与生态效益的有机统一.     

河流健康评价标准研究——以贾鲁河流域郑州段为例

阐述了河流健康以及河流健康评价的概念,论述了河流健康评价的发展以及标准制定的原则和依据。并以贾鲁河流域(郑州段)为例,从生境状况、生物状况、生态功能三方面着手构建河流健康评价指标体系,并论述了该体系中各指标变量标准建立的过程。     

间隔流动分析法测定水中总磷

采用间隔流动分析法(SFA)测定地表水和城镇污水处理厂废水中的总磷,并与现行国标方法作比对,发现悬浮物对SFA法的结果存在一定的干扰,并对此进行了详细讨论且设计了一系列实验。实验结果表明使用均质机对水样均质能够有效消除悬浮物对测定结果的影响。水样经均质处理后两种方法测定结果相对误差小于3.0%。SFA法绘制的校准曲线线性大于0.999 5,标准样品的平行测定RSD≤1.5%,方法检出低限为0.009 mg/L,地表水样品加标回收率为91.4%～97.7%。     

试论中国城市公共安全规划与应急管理体系建设

1国内外公共安全形势与城市公共安全的新挑战 　　进入21世纪,国际公共安全形势日趋严峻,城市面临的灾害形势从传统的自然灾害、火灾、瘟疫等为主扩大到传统灾害和生命线系统故障、信息安全、恐怖事件等非传统灾害共同影响的情况,呈现出以下特点:重大自然灾害的发生频率、量级加大,经济损失更严重;随着工业化、现代化和城市化的发展,事故灾难以及复合型事件的影响日益突出;生物和公共卫生危机严重威胁和影响公众健康;恐怖主义威胁呈现出新型化、大规模化和强灾难性的特点;经济危机连锁反应,各种社会危机交相激荡.……     

加油站油气回收系统分析与关键技术研究

深入分析了加油站平衡式油气回收系统、真空泵辅助式油气回收系统的美国模式和德国模式的油气回收效率和关键技术问题,揭示了密封性是平衡式失败和美国模式低效的根本原因,解决了困扰业界的罐压不高、罐压保持、后处理装置是否必要等困惑和争议,提出高效率、低密封性要求的"低罐压真空泵辅助式油气回收系统"技术方案和实施方案。     

高温下好氧污泥接种启动UASB的试验研究

采用高温UASB处理柠檬酸废水,研究利用好氧脱水污泥接种启动高温UASB的可行性。试验结果表明,在温度55℃,HRT为6天的条件下,UASB反应器能降解的柠檬酸废水浓度为10000mg/L,容积负荷为1.67gCOD/(L.d),柠檬酸废水的去除率达到90%以上。     

Ultrasonic preparation of nano-nickel/activated carbon composite using spent electroless nickel plating bath and application in degradation of 2,6-dichlorophenol

Ni was effectively recovered from spent electroless nickel （EN） plating baths by forming a nano-nickel coated activated carbon composite. With the aid of ultrasonication, melamine- formaldehyde-tetraoxalyl-ethylenediamine chelating resins were grafted on activated carbon （MFT/AG）. PdC12 sol was adsorbed on MFT/AC, which was then immersed in spent electroless nickel plating bath; then nano-nickel could be reduced by ascorbic acid to form a nano-nickel coating on the activated carbon composite （Ni/AC） in situ. The materials present were carefully examined by Fourier transform infrared spectroscopy, X-ray diffraction, field emission scanning electron microscopy, X-ray photoelectron spectroscopy and electro- chemistry techniques. The resins were well distributed on the inside and outside surfaces of activated carbon with a size of 120 ± 30 nm in MFT/AC, and a great deal of nano-nickel particles were evenly deposited with a size of 3.8 ± 1.1 nm in Ni/MFT. Moreover, Ni/AC was successfully used as a catalyst for ultrasonic degradation of 2.6-dichloronhenol.     

Efficient dechlorination of chlorinated solvent pollutants under UV irradiation by using the synthesized TiO2 nano-sheets in aqueous phase

Titanium dioxide(TiO2), which is the widely used photo-catalyst, has been synthesized by simple hydrothermal solution containing tetrabutyl titanate and hydrofluoric acid. The synthesized product has been applied to photo-degradation in aqueous phase of chlorinated solvents, namely tetrachloroethene(PCE), trichloroethene(TCE) and 1,1,1-trichloroethane(TCA). The photo-degradation results revealed that the degradation of these harmful chemicals was better in UV/synthesized TiO2 system compared to UV/commercial P25 system and UV only system. The photo-catalytic efficiency of the synthesized TiO2 was 1.4, 1.8 and 3.0 folds higher compared to the commercial P25 for TCA, TCE and PCE degradation, respectively. Moreover, using nitrobenzene(NB) as a probe of hydroxyl radical(.OH), the degradation rate was better over UV/synthesized TiO2, suggesting the high concentration of.OH generated in UV/synthesized TiO2system. In addition,.OH concentration was confirmed by the strong peak displayed in EPR analysis over UV/synthesized TiO2system. The characterization result using XRD and TEM showed that the synthesized TiO2 was in anatase form and consisted of well-defined sheet-shaped structures having a rectangular outline with a thickness of 4 nm, side length of 50 nm and width of 33 nm and a surface 90.3 m2/g. XPS analysis revealed that ≡Ti-F bond was formed on the surface of the synthesized TiO2. The above results on both photocatalytic activity and the surface analysis demonstrated the good applicability of the synthesized TiO2 nano-sheets for the remediation of chlorinated solvent contaminated groundwater.     

Quantitative method to determine the regional drinking water odorant regulation goals based on odor sensitivity distribution：Illustrated using 2-MIB

Taste and odor （T/O） in drinking water often cause consumer complaints and are thus regulated in many countries. However, people in different regions may exhibit different sensitivities toward WO. This study proposed a method to determine the regional drinking water odorant regulation goals （ORGs） based on the odor sensitivity distribution of the local population. The distribution of odor sensitivity to 2-methylisobomeol （2-MIB） by the local population in Beijing, China was revealed by using a normal distribution function/model to describe the odor complaint response to a 2-MIB episode in 2005, and a 2-MIB concentration of 12.9 ng/L and FPA （flavor profile analysis） intensity of 2.5 was found to be the critical point to cause odor complaints. Thus the Beijing ORG for 2-MIB was determined to be 12.9 ng/L. Based on the assumption that the local FPA panel can represent the local population in terms of sensitivity to odor, and that the critical FPA intensity causing odor complaints was 2.5, this study tried to determine the ORGs for seven other cities of China by performing FPA tests using an FPA panel from the corresponding city. ORG values between 12.9 and 31.6 ng/L were determined, showing that a unified ORG may not be suitable for drinking water odor regulations. This study presents a novel approach for setting drinking water odor regulations.